Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateStyles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
See the difference
Before
After
Before
After
Before
AfterHow Much Does Gate Access Control Cost in Pompano Beach?
Gate access control in Pompano Beach typically runs $350 to $1,800 for a residential system, depending on whether you’re repairing an existing setup or adding new keypads, card readers, and intercoms to a gate you already have. A straightforward keypad swap usually lands near the low end. A full access-control retrofit on a commercial slide gate with vehicle loop detectors and a call box pushes toward the high end, and sometimes past it. The written estimate you get after an on-site look is what sets the final number.
We’re a dedicated gate specialist, and access-control pricing is where generalists tend to guess. The control board, the reader, the wiring, the motor that actually moves the leaf: these all interact, and the price changes depending on which part is the real problem. Our technicians have up to 12 years of experience diagnosing exactly that.
Key Takeaways
- Residential keypad or card reader replacement in Pompano Beach: roughly $350 – $750 installed.
- Full residential access-control retrofit (keypad, receiver, wiring, board): $650 – $1,200.
- Commercial access-control setup with vehicle loops and call box: $1,100 – $1,800 and up.
- Motor and control board work often overlaps with access control, so we diagnose before quoting.
- Estimates are free, and the written quote is what you pay. Call (888) 399-8022.
Gate Access Control Cost Breakdown (2026)
Here’s how access-control line items typically price out in the Pompano Beach market for 2026. These are ranges for the work itself, and each one is confirmed by the written estimate after we’ve looked at your gate.
| Line item | Typical 2026 range (Pompano Beach) |
|---|---|
| Keypad replacement (residential or light commercial) | $350 – $650 |
| Card reader or proximity reader install | $450 – $900 |
| Intercom or call box installation | $400 – $850 |
| Control board replacement (access-control board) | $400 – $900 |
| Receiver and remote programming (new remotes) | $150 – $350 |
| Vehicle loop detector install (commercial) | $350 – $700 per loop |
| Wiring runs and conduit for access points | $300 – $900 depending on distance |
| Full residential access-control retrofit | $650 – $1,200 |
| Full commercial access-control setup | $1,100 – $1,800+ |
What moves a number up or down is usually the wiring. If your gate already has conduit and a functioning board, swapping a keypad is quick and affordable. If we’re running new wire from the house to the gate, or adding loops in the driveway for a commercial slide gate, that labor and material adds real cost. The motor is a separate concern. Access control tells the gate when to open; the motor does the opening. When the motor is failing, we quote that separately, and the two repairs sometimes come bundled into one visit.
We work on the brand you already have: LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule. If your access-control hardware carries one of those names, we’re not going to shrug at it or refer you to a shop that only knows one system. The board, the reader, and the wiring are all in the same diagnostic pass.
What Affects Gate Access Control Pricing in Pompano Beach
Pompano Beach gates live outdoors in a hot, humid, sunny climate. That shapes pricing here in ways it wouldn’t in a milder place. Below are the factors that most often change what you’ll pay.
- Sun exposure on the control board and readers. Boards and keypads mounted facing direct afternoon sun run hotter and fail sooner, so replacement frequency is higher here than in cooler climates. A shaded mount location reduces future cost.
- Humidity and moisture at the control enclosure. Humid air finds its way into enclosures that aren’t sealed well, and moisture on a board is a common reason readers stop responding. A proper weather-rated housing is part of the estimate when needed.
- Wiring distance from the house or the nearest power. A gate set 30 feet from the house costs less to wire than one at the end of a long driveway. Distance drives conduit and wire cost.
- Residential vs. commercial duty. A residential swing gate with a keypad is a simpler job than a commercial slide gate with vehicle loops, a call box, and heavy-duty readers. Commercial-grade DoorKing and similar systems sit on the higher end of the scale.
- Whether the problem is the access control or the motor. A keypad that won’t open a gate can look like a reader failure when the real cause is a motor or board issue. Accurate diagnosis first is what keeps the cost down; a guess-and-replace approach can double the bill.
- Condition of the gate and hardware itself. A sagging gate that drags on the ground strains the operator and the board. Sometimes the access-control fix includes correcting the hinge and track so the system stops chewing through parts. We address both, since we cover the motor, the control board, the mechanical hinge, and the structure.
Neighborhood context matters less than gate design, but it’s worth knowing that the mix of homes and commercial property across Pompano Beach means we see everything from single-driveway swing gates to multi-tenant commercial slides. If your gate is on a commercial property with shared access, the access-control estimate will include the readers and loops, not just the operator.
How to Save on Gate Access Control
The biggest cost saver in access control is diagnosis before replacement. A technician who’s seen the failure modes on your specific brand can tell whether you need a new reader or just a programming reset, and that distinction is the difference between a $200 visit and an $700 one. Here’s what we tell property owners before they call.
- Get the free estimate. We come out, look at the gate and the access-control hardware, and quote the job in writing. There’s no charge for that visit, and the written estimate is the final price. Call (888) 399-8022.
- Tell us the brand up front. If your system is a LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, or Mighty Mule unit, say so when you call. We’re familiar with all nine, and it lets us bring the right parts and the right knowledge from the start.
- Describe the symptom accurately. “The keypad beeps but the gate doesn’t move” is different from “the gate moves but the card reader won’t read.” The symptom narrows the diagnosis and often shortens the visit.
- Don’t let a small issue sit. A keypad that only works intermittently, or a board that occasionally clicks and doesn’t respond, usually costs less to fix early than after it fails completely. Catching it early avoids an emergency repair.
- Bundle related work into one trip. If the same gate needs access-control work and a hinge fix, doing them together saves a second visit. We quote the whole job at once.
We don’t default to replacement. Brand-agnostic troubleshooting on the actual problem is how we keep costs sane for homeowners and property managers who depend on their gate every day. If you’re not sure whether your issue is access control or the motor, see our gate repair pompano beach page, which covers the repair side in detail.
Repair or Replace Access Control: Which Costs Less?
Repair almost always costs less when the hardware is sound and the failure is isolated. Replacing a single keypad or board runs $350 – $900, while a full access-control retrofit runs $650 – $1,200 residential or $1,100 – $1,800+ commercial. Replace when the board is failing repeatedly, when the reader and control hardware are outdated and parts are hard to source, or when the gate is being automated for the first time. For a first-time automation, the access-control piece sits alongside a new operator, and the whole job gets quoted together.
This is where whole-system knowledge pays off. A board that fails every few months may be taking damaging surges from a motor that’s drawing too much current, and replacing the board without addressing the motor just repeats the cost. We look at the motor, the board, and the hardware in one pass, so the recommendation is based on the actual cause.
What Happens When You Call
When you call, you’ll describe the gate and the symptom, and we’ll book an on-site visit to look at the access-control setup. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. We’re closed on Saturday. A call outside dispatch hours is booked into the next opening, Sunday through Friday, 7am to 7pm.
At the visit, a technician inspects the gate, the motor, the board, and the access hardware, then quotes the job in writing. No guesswork, no surprise charges. The number on that estimate is what you pay. Same-day service is often possible for access-control failures that leave a property without working entry.
We handle emergency repair, electric gate repair, and new gate installation under one provider, so if the access-control diagnosis points toward a failing motor or a worn gate, you’re not hunting for a second company. Whether it’s the motor, the board, or the hardware, the same specialist handles it.
FAQs – Gate Access Control Cost
How much does a gate keypad cost to replace in Pompano Beach?
A residential keypad replacement in Pompano Beach typically runs $350 to $650 installed, and a commercial keypad or reader can run $450 to $900. The range depends on the brand and whether the wiring is already in place. Call (888) 399-8022 for an exact quote on your gate; estimates are free.
Is it cheaper to repair or replace my access-control board?
Repairing an access-control board costs less when the failure is a single component or a settings issue, often $400 to $900 for a board replacement versus a full retrofit at $650 to $1,200. Replacement makes sense when the board fails repeatedly or parts are hard to source. We diagnose first so we’re not replacing something that only needs a reset. Call (888) 399-8022.
Can you work on my gate access-control brand?
Yes if it’s one of the nine we service: LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, or Mighty Mule. That covers most residential and commercial systems out there, so you won’t get referred elsewhere when your brand isn’t the shop’s only specialty. Call (888) 399-8022 and tell us the brand.
How much does commercial gate access control cost in Pompano Beach?
A commercial access-control setup with readers, vehicle loops, and a call box typically runs $1,100 to $1,800 and up, with vehicle loop detectors running $350 to $700 per loop. The total depends on how many access points and how much new wiring the site needs. Call (888) 399-8022 for a written estimate.
Can you come today if my gate access control fails?
Often yes. Same-day service is usually possible for access-control failures that leave a property without working entry. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. A call outside dispatch hours is booked into the next opening. Call (888) 399-8022.
Does a new access-control reader always fix a gate that won’t open?
No. A gate that won’t open can have a failing reader, a bad board, a dead motor, or a wiring fault, and only diagnosis tells you which. We check all of them on the same visit so you don’t pay for a reader you didn’t need. For the repair side of that diagnosis, see our gate repair pompano beach page. Call (888) 399-8022.
Why a Gate Specialist for Access Control
Access control sits at the intersection of electronics, wiring, and the gate’s own mechanical health, and that’s a narrow thing to be good at. We’re a dedicated gate technician outfit. Every tool and every part we bring is focused on gates, not split across unrelated trades. That focus is why we can tell you, on the first visit, whether the problem is a reader that’s failed or a motor dragging current and taking the board with it.
For property managers across Pompano Beach, that matters because access control isn’t a one-off. It’s the system that decides who gets in every day, and downtime is expensive. Our approach is accurate diagnosis first, then a written estimate, then the work. No parts-swapping, no unnecessary replacements.
We’re independent and experienced with the nine brands we service; we’re not tied to any single manufacturer. That means the recommendation comes from what your gate actually needs, not from what one brand’s parts catalog pushes. If the motor needs work, we handle it. If the board needs replacing, we handle that. If the gate’s hinges are sagging and straining the operator, that’s in scope too.
Getting Your Access-Control Estimate
If you’ve got a gate keypad that won’t respond, a reader that only works sometimes, or a commercial entry system that needs a full access-control setup, the next step is a free estimate. Call (888) 399-8022. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. The estimate is free, the price is set per job in writing, and the technician who shows up knows your brand. For more on the repair side, our gate repair pompano beach page covers the common failure modes, and our Pompano Beach page lists the neighborhoods we serve.
Pricing reflects the Pompano Beach market as of 2026. Gate Repair Pompano Beach offers free estimates – call (888) 399-8022.
Written by the team at Gate Repair Pompano Beach.
What Our Customers Say
"We had a hydraulic arm leaking fluid onto the driveway. Replaced, cleaned up the stain as best he could, and it's been dry for months."
- Diego Reyes"Gate works properly now and the price was fair. The one thing is that it took two visits, because the operator model we have is old and the part had to be ordered. They didn't charge for the second trip."
- Jamal Carter"Repair is holding. He was quite a bit later than the window I was given, and nobody called me about it, I had to call them. The work itself was done well once he got here."
- Hector Rodriguez